6288-7904 - MATERIAL ORDERING DATA

MATERIAL ORDERING DATA

ASTM-A6/A6M

Any specification that is referenced in this Material Order Data sheet is required to be to the latest revision at time of award.

IDN: N4523A 6288-7904

ICN: 88MSM00001 KO: 000

KOI: 000

Paragraph 4 Ordering Data

ASTM-A6/A6M, STANDARD SPECIFICATION FOR GENERAL REQUIREMENTS FOR

ROLLED STRUCTURAL STEEL BARS, PLATES, SHAPES AND SHEET PILING, dated 27 APR 2026.
4.1.1 Select ASTM product specification designation and year-date: A36/A36M
Select One (cont.):

4.1.2 Name of structural product: BAR

4.1.3 Shape designation, or size and thickness or diameter: 7” DIA. 4.1.4 Grade, Class and Type designation, if applicable: Grade: N/A
Class: N/A
Type: N/A
4.1.5 Condition, if other than as-rolled (see Section 6): N/A
4.1.6 Quantity (weight [mass] or number of pieces):

20 FEET

4.1.7 Length: 10 FT. LENGTHS.
4.1.8 Exclusion of either structural product produced from coil or structural product from coil or structural product produced from an as-rolled structural product, if applicable (see 5.4 and Appendix X1):
N/A
4.1.9 Heat treatment requirements (see 6.2 and 6.3), if any: N/A
4.1.10 Testing for fine austenitic grain size (see 8.3.2): IS NOT REQUIRED.

MATERIAL ORDERING DATA

ASTM-A6/A6M

4.1.11 Mechanical property test report requirements (see Section 14) IS required.
Test report for each heat supplied is required IAW spec Section 14. 4.1.12 Special packaging, marking, and loading for shipment requirements (see Section

19): IAW MIL-STD-129

4.1.13 Supplementary requirements, if any, including any additional requirements called for in the supplementary requirements. Checked below apply: S1. Vacuum Treatment
NOT REQUIRED.
S2. Product Analysis
NOT REQUIRED.
S3. Simulated Post-Weld Heat Treatment of Mechanical Test Coupons NOT REQUIRED.
S4. Additional Tension Test
NOT REQUIRED.
S5. Charpy V-Notch Impact Test
NOT REQUIRED.
S6. Drop-Weight Test (for Material 0.625 in. [16 mm] and over in Thickness) NOT REQUIRED.
S8. Ultrasonic Examination
NOT REQUIRED.
S15. Reduction of Area Measurement
NOT REQUIRED.
S18. Maximum Tensile Strength
NOT REQUIRED.
S23. Copper-Bearing Steel (for improved atmospheric corrosion resistance) NOT REQUIRED.
S26. Subdivided Material—Marking of Individual Pieces
NOT REQUIRED.
S27. Restrictive Plate Flatness
NOT REQUIRED.
S28. Fine Grain Practice
NOT REQUIRED.
S29. Fine Austenitic Grain Size
NOT REQUIRED.
S30. Charpy V-Notch Impact Test for Structural Shapes: Alternate Core Location