A Statement of Work Rolls Royce 1K MAINT.doc

ABSTRACT

This item describes technical services for the Main Propulsion Diesel Engines FOR 1K hour maintenance.

REFERENCES: None

ITEM LOCATION/DESCRIPTION:

Locations:
Engine Room 1 (5-52-1)
Engine Room 2 (5-52-2)
Quantity:

4 Engines Total (2 each location)

GOVERNMENT FURNISHED MATERIAL/EQUIPMENT/SERVICE: None

NOTES:

Performance Period:

15 Feb – 07 March 2027

Location of Work:
Naval base Norfolk or JEB Little Creek or Fort Story, VA, 23459, Pier: TBD. Port Engineer:
Port Engineer: Darren Randall
Cell: (757)342-5010
E-mail: [email protected]
Contact the Port Engineer for details and requirements concerning access to an MSC vessel.

Current base access procedure is to file a SECNAV Form 5512 DoN Access Pass Registration and an OPCON Access Request form with the Pass and ID office at least 14 days prior to the date of base access. OPNAV Access Request shall be submitted by a Government CAC ID holder (DOD Employee) to Force Security. QUALITY ASSURANCE REQUIREMENTS: None Additional.

STATEMENT OF WORK REQUIRED:

Provide the services and material for Authorized MTU OEM Representatives for performance period stated in 5.1. OEM Rep’s shall travel to ship location for the performance periods specified. Service Representatives shall provide all tools, material and labor to execute the requirements as delineated below for the MTU 1K hour service and as follows. All work will be IAW MTU standard maintenance for EPF-15 Propulsion systems. Task 1 "Perform L/O low pressure, over speed, and J/W high temperature safety shutdown demonstrations for ABS annual testing on all four MPDEs." Task 2 Engine Inspection to determine Hose configuration Task 3 Hose replacement, tagging and spray shield installation Task 4 Rubber Bellows replacement.
WM00066 ENGINE MOUNTING: Measure height of rubber element WM00063 "LUBE OIL SYSTEM: Automatic centrifugal oil filter, check layer thickness of oil residue, clean, and replace paper element at every engine oil change at the latest" WM00126 ENGINE MOUNTING: Measure height of rubber element WM00128 ENGINE MOUNTING: Measure buffer clearance, adjust if necessary WM00050 ENGINE MOUNTING: Check general condition of rubber mounts (visual inspection) WM00136 ENGINE MOUNTING: Check securing screws for firm seating WM01587 STARTING SYSTEM: Lubricate starter ring gear
WM01593 STARTING SYSTEM: Check screw connections of starter ring gear to intermediate ring and of starter intermediate ring to coupling for secure seating