Attachment 5: Request for Proposals FAR Provision 52.225-6 Trade Agreements Certificate Fillable

895350186181DEPARTMENT OF VETERANS AFFAIRS (VA)

VA’S FY26 ETMPM-TENS Procurement Program Recompete
Solicitation Number 36C79126R0011

FAR Provision 52.225-6, Trade Agreements Certificate.
Instructions to Offerors: Attachment 0005, FAR Provision 52.2256, Trade Agreements Certificate, is a mandatory, fillable document required for all Offerors submitting a proposal under Solicitation Number 36C79126R0011. Submission of a fully completed, signed, and dated Trade Agreements Certificate is a material condition of responsiveness. Any Offeror that fails to submit this attachment exactly as required will be deemed nonresponsive and will be eliminated from further evaluation and ineligible for award. General Completion Requirements: Offerors must complete the fillable PDF document in its entirety. The following actions are required: Enter all information into the fillable PDF exactly as instructed.

Insert check marks in all boxes where the Offeror must certify or indicate selections.

Complete all fields identifying:

CLINs and SLINs applicable to the Offeror’s proposed foreign end-products; and

Enter the countryoforigin information for each CLIN/SLIN listed item.

Ensure the document certificate contains a valid digital signature applied by an authorized representative of the Offeror. Typed signatures, inserted JPEG signatures, or hand written signatures without digital authentication are not acceptable. Only digital or electronic signatures compliant with federal acquisition standards (e.g., Adobe, DocuSign, PKI based signature) will be accepted.

Enter the date signed in the designated field.

Ensure all content is truthful, complete, and consistent with representations submitted in Attachment 0003 (FAR 52.2123), the Price Matrix, and the Offeror’s active SAM.gov registration.

Required Offeror Representations & Certifying Selections: Attachment 0005 requires Offerors to certify compliance with the requirements of FAR Provision 52.2256. The Offeror must: U.S.-Made or Designated Country End-Products Certification: Certify that all end-products offered, except those listed as foreign are U.S.-made or designated country end-products as defined in the RFO Clause at 52.225-5, titled “Trade Agreements.”

Listing of Foreign End Products: For any end product that is not a U.S.-made or designatedcountry item, the Offeror must list that product in the table provided under paragraph (b) of this provision. The Offeror must complete the table exactly as shown and include: Enter CLIN or SLIN,