Dredge and Plant Characteristics Sheet
Updated
A PDF document (92 KB) attached to Lease of One Cutterhead, Hydraulic Pipeline Dredge (Not Less Than 18-Inch Diameter), Fully Operated with Attendant Plant and Personnel, and with a Draft not to Exceed 9 Feet, for Construction and Maintenance Dredging within the Vicksburg District, from the Department of the Army. Due Nov 10, 2026, 12:00 PM (UTC-6).
File name: Dredge and Plant Characteristics Sheet.pdf
The full file is for paid members, or buy this bid alone.
Preview
DREDGE AND ATTENDANT PLANT CHARACTERISTIC SHEETS
In compliance with the above dated Request for Proposals, the Offeror hereby proposes to furnish, deliver and operate the following plant in strict accordance with the Contract Clauses, (Construction Contract), specifications, schedules, drawings, and conditions, for the amount(s) shown on the Pricing Schedule attached. One Cutterhead, Hydraulic Pipeline Dredge and Attendant Plant with the following characteristics: Dredge Name or Number:
HULL:
Length, feet
Breadth, feet
Depth, feet
Draft under normal working conditions, feet
Minimum width of channel in which dredge can successfully operate, feet Minimum depth of water in which dredge will operate, feet Maximum draft of dredge, feet
Maximum current in which dredge can successfully operate, feet per second for 15-ft depth of water
Maximum current in which dredge can successfully operate, feet per second for 30-ft depth of water
Depth to which dredge will dig:
Maximum
Minimum
Maximum width of cut dredge can make without exceeding 45 swing angle
LADDER:
Length, feet
Length ladder can be extended, feet
Normal r.p.m. of cutter
Brake H.P. of cutter
DREDGING PUMP:
Diameter suction, inches
Diameter discharge, inches
Maximum r.p.m. of impeller
Method of actuating impeller:
( ) Steam Engine
( ) Diesel Engine
( ) Electric Motor
( ) Other (check one)
Brake hp applied to pump impeller
UNDERWATER PUMP:
Diameter suction, inches
Diameter discharge, inches
Maximum r.p.m. of impeller
Method of actuating impeller:
( ) Diesel Engine
( ) Electric Motor
( ) Other (check one)
Brake hp applied to pump impeller
MAIN PUMP ENGINE
Make:
Model:
Type:
Size:
Age:
BHP:
RPM:
Estimated Amount of Fuel Consumed per Day
Two
Tenders
Name
HULL
Length, feet
Molded Beam, feet
Draft, feet
When Built, year
Tender #1
300 H.P.
Tender #2
600 H.P.
PROP. ENGINES:
Port
Starboard
Port
Starboard
Make:
Model:
Serial No.:
Basic Brake HP:
INSPECTOR’S SKIFF:
Manufacturer:
Model:
Length:
Upright & Level Floatation installed by:
Outboard Motors:
Motor 1
Motor 2
Manufacturer:
Horsepower:
THE PLANT WAS LAST OPERATED IN
(month, year), AT
(location).
The beginning of the document. Download the full file to read on.