EDR

REV:

ENGINEERING DATA REQUIREMENTS

(ATTACHMENT “A”)

NOTE: MILITARY SPECIFICATIONS / STANDARDS WILL NOT BE FURNISHED IN THE BID SET.

1.THE FOLLOWING INSTRUCTIONS ARE FURNISHED FOR THE MANUFACTURE OF:

Circuit Card Assembly

2. PART NUMBER:

2217255

3. NATIONAL STOCK NUMBER:

5998015053907WF

Deviations from specifications identified in drawings or this document are not authorized without prior approval by 416 SCMS/GUEAA Engineering.

IUID (Item Unique Identifier) requirements and expectations which the contractor must ensure are complied with.

a. Contractors drawings shall be changed or supplemented by contractor for IUID compliance. b.. Label shall contain all data on existing label, (if existing label is to be replaced), only delete existing label with government engineering permission.
c. Use HRI (Human Readable) and Machine Readable Matrix. (USAF not equiped to read barcode). d. IUID Matrix needs to be highly visible, in a location easily accessible. e. IUID marking must be permanent.
f. MIL-STD-130, ISO 15434, ISO 15415, and ISO 15418, (Part Marking as per MIL-STD-130 in lieu of FPS-3008) i. IUID marking specifications.
1. Minimum 1/8 inch lettering on Human readable to include: a. Cage (17V)

b. P/N (1P)

c. Serial Number (IS)
2. Minimum 1/4 inch square on Machine Readable 2D Matrix -construct 2 - to include a. Cage (17V)

b. P/N (1P)

c. Serial Number (IS)

///////////////
Counterfeit Prevention
1. Counterfeit Prevention Plan (CPP). Contractors that supply electronic parts or systems that contain electronic parts shall establish policies and procedures to avoid, detect, mitigate and disposition counterfeit electronic parts to prevent such parts from entering the USAF/DoD supply chain. These policies and procedures shall be documented in a CPP for submission and approval in accordance with Data Item Description (DID) DIMISC-81832 and accomplished for all specified contract items. DI-MISC-81832 is applicable to Parts, Material and Processes Selection (PMPS) associated with delivery of systems and assemblies to the USAF and DoD. The requirements established by DI-MISC-81832 also apply to electronics components procured in sustainment of such systems and assemblies. The requirements of the recently DoD-adopted SAE 5553, Aerospace Standard, Counterfeit Electronics Parts; Avoidance, Detection, Mitigation, and Disposition shall also apply. 2.0. At a minimum, the CPP shall address:
2.1. Applicability. The Contractor shall identify all Business locations and programs to which the CPP applies. The CPP shall address materials,