Exhibit C.1 - - Carolina PR - DEA Security Statement of Work

Exhibit C.1

DEA STATEMENT

OF WORK –

GENERIC

September 30

2026

This summary applies to the procurement, installation, training and implementation of an integrated security management system for the site described.

General
Requirements,
specifications
and system
components.

Exhibit C.1

DEA SECURITY SYSTEM

SECTION I - GENERAL REQUIREMENTS

1.01 Summary of Work

DEA Office of Security Programs will review all vendor contract proposals for technical accuracy, completeness, and suitability, and will make the final determination of selected security vendor based on the most technically capable and lowest acceptable bid. This summary applies to the procurement, installation, training and implementation of an integrated security management system for the site described. The contractor shall furnish a complete system including all labor, materials and equipment for a functional security system. Use of subcontractors and/or other vendors to install and maintain any or all the security system(s) (other than cabling, conduit, and power) must be approved in advance by DEA Headquarters, Physical Security Section. GSA or open market pricing shall be used, whichever is more advantageous to DEA.

1.02 Systems, warranties and maintenance

The work included as specified herein and as shown on the contract drawings consists of, but is not limited to, the following: a.
b.
c.
d.
e.
f.
g.

Access Control System (ACS)
Video Surveillance System (VSS)
Intrusion Detection System (IDS)
Warranty coverage
Systems tracking
Submittals and shop drawings
Maintenance and service support

1.03 Preexisting conditions

The contractor shall visit the site, check all existing conditions and be satisfied with the conditions under which the work is to be performed before submitting the project bid. No allowances shall be made for any extra expense due to the contractor’s failure or neglect to discover prior conditions affecting the work, to include hardware and labor necessary to complete the work.

1.04 Location of Work

1.05 Equipment

All equipment provided must be fully compliant with NDAA H.R. 5115 also known as the John S. McCain National Defense Authorization Act, as well as Trade Agreements Act (TAA) FAR 52.255-5. TAA compliance applies to all equipment provided for the project, not solely products listed on the GSA Schedule Contract. Substitution of equipment after bid approval will occur only when there is a significant advantage to the client agency, created by an overall upgrading of a component(s) by a manufacturer or an operational advantage created by a change in the state of the