Home / Bar, Metal / Document

MATERIAL ORDERING DATA

Updated

A PDF document (98 KB) attached to Bar, Metal, from the Defense Logistics Agency. Due Nov 17, 2026, 2:00 PM (UTC-8).

File name: MATERIAL ORDERING DATA - ASTM-B-150.pdf

Download the full documentSee the bid

The full file is for paid members, or buy this bid alone.

Preview

MATERIAL ORDERING DATA

ASTM-B-150

Any specification that is referenced in this Material Order Data sheet is required to be to the latest revision at time of award.

IDN: N4523A 6288-7903

ICN: 88MSM00001 KO: 000

KOI: 000

Paragraph 4 Ordering Data
A. ASTM-B-150/B150M, STANDARD SPECIFICATION FOR ALUMINUM BRONZE ROD, BAR, AND SHAPES, dated 19 JANUARY 2026.
B. Copper alloy UNC No. (see Table 1): C64200
C. Temper (see 7.1): M20 – AS HOT ROLLED
•

When Alloy UNS No. C63000 is specified, specify standard strength or high strength temper (see Table 2).

D. Product cross-section (for example round, hexagonal, square, and so forth): ROUND E. Dimensions (diameter or distance between parallel surfaces and length) and permissible variations (section 10): 4” DIAMETER
•

When product of Copper Alloy UNC No. 63020 is specified, the tolerances for diameter, thickness, width, and length shall be part of the contract or purchase order and shall be agreed upon between the supplier and the purchaser.

•

Shapes – When product is shapes, the dimensional tolerances shall be as agreed upon between the manufacturer and the purchaser and shall be specified.

F. Quantity: 10 FOOT LENGTH

Total Weight:
Footage:
Number of pieces for each size: 1 EACH
G. The product is being purchased for agencies of the U.S government. H. If Copper Alloy C61300 material is intended for subsequent welding applications (see Note B, Table 2): N/A

I. Certification: NOT REQUIRED

J. Mill test reports: REQUIRED WITH SHIPMENT
K. Residual stress test IS NOT required.
a. Ammonia Vapor Test or Mercurous Nitrate Test (if required): N/A b. For Ammonia Vapor Test, pH value other than 10 (if required): N/A L. Piston finish or shafting IS NOT required.
M. Tensile test IS required for alloys with hardness requirements.

Additional Data Requirements:
N/A
All unit, intermediate and shipping containers must be marked in accordance with MIL-STD129. Refer to DLA Procurement Note C20 for further instructions. Prepared By: Material and Technical Support
Code: 244.4

The beginning of the document. Download the full file to read on.

Other documents in this bid