Secured Parking Cage Construction Scope - Minimum Requirments

Secure Parking Construction General Requirements
The confines of the chosen location will allow parking the stated number of vehicles within an environmentally mitigated location to protect the vehicles from exposure to weather and temperature extremes.
Access: All routes leading to and into the secure location will need to have a minimum vertical clearance of 6 Feet 8 Inches.
Weight Capacity: All routes leading into the space must have a load bearing capacity of no less than 11,500 pounds and the storage area must accommodate this load for each parking space protected. Adequate Space: The overall allotment will afford space to allow adequate room to navigate 6’8” by 19’ vehicles safely into the spaces and enough space to enter, exit, and circulate around the vehicles while parked. Estimated space needed per vehicle is 9’ 6”, this spacing provides 2’ of clearance on each side of each vehicle.
Walls: The walls of the cage will be heavy gauge (9 gauge) or equivalent chain link fence supported by steel pipe. The fence will be covered with an opaque visual deterrent that provides full visual separation from the non USSS space of the adjacent area. Depending on location and situation solid walls may need to be constructed to achieve the necessary security of the vehicles. Vehicle Access: Access to space should have a rollup door if the height allows. If height is limited and width allows a folding or rolling chain link or similar partition with visual deterrent can be installed. If the height and width are not adequate, then swing Gates can be used. Any door or access provision will need to be able to be fitted with a locking mechanism that can support a Medeco 6 pin Large Format Interchangeable Core lock system and Intrusion detection system (IDS) sensing equipment. Personnel Access: Personnel access to the space should be steel doors in a steel frame, 16 gauge minimum. All doors need to able to be fitted with a Medeco 6 pin Large Format Interchangeable Core lock system and Intrusion detection system (IDS) sensing equipment.

Electrical and Data Support: Each vehicle storage location will be provided a ¾ inch plywood backer to mount equipment located on a vertical wall within the confines of the storage area or a free-standing securable rack. This backer will be sized and located based on the number of vehicles enclosed and local condition requirements. The rack will be the termination point for power and data conduits if a suitable wall is not available for a backer board. The provisions below are general in nature and additional