Home / TS-405 Vessel / Document

Statement of Work

Updated

A PDF document (350 KB) attached to TS-405 Vessel, from the National Aeronautics and Space Administration. Due Nov 19, 2026, 4:00 PM (UTC-6).

File name: SOW.pdf

Download the full documentSee the bid

The full file is for paid members, or buy this bid alone.

Preview

NASA | WHITE SANDS TEST FACILITY

STATEMENT OF WORK

Fabrication and Delivery of Two 200-Gallon, 2,000 psig Pressure Vessels

Delivery Location

NASA White Sands Test Facility (WSTF)
12600 NASA Road
Las Cruces, NM 88012

Fluid Service

Compatible with Monomethyl Hydrazine (MMH), Nitrogen Tetroxide (N₂O₄) service

Quantity

Two - identical pressure vessels

Acquisition Basis

Exact configuration of vessels built for TS403 (reference data plates on following pages)

Target Lead Time

Approximately 20 to 30 weeks after award, subject to confirmed production schedule

Vendor

Prentex Alloy Fabricators, Sunnyvale Texas

1. Background

NASA is reactivating TS405 to support mission critical propulsion test capability at WSTF. The project requires two pressure vessels for the TS405 propellant skid. The required vessels are to duplicate the proven vessel configuration already in service at TS403.

2. Objective

Provide two complete, ASME code stamped pressure vessels that match the TS403 vessel configuration (S/N, E250, E-251). The vendor shall fabricate, test, document, preserve, and ship the vessels to WSTF.

3. Technical Requirements










Quantity: Two identical pressure vessels
Nominal capacity: 200 gallons each
Maximum allowable working pressure/design pressure: 2,000 psig (minimum). Design temperature range: -20 °F to +150 °F.
Material: Stainless steel 304/304L.
Fluid Service: Monomethyl hydrazine (MMH), Nitrogen Tetroxide (N₂O₄). All wetted materials, fabrication processes, cleanliness provisions, etc. shall be suitable for the specified hypergolic propellant service. Configuration: Match the NASA approved TS403 vessel configuration (S/N – E-250, 251), vendor to provide submittal drawing to be approved by NASA prior to fabrication. Code: Design, manufacture, inspect, test, and stamp in accordance with the applicable edition of ASME Boiler and Pressure Vessel Code, Section VIII, Division 1. Register each vessel with the National Board. Interchangeability: Critical dimensions, nozzle locations, interfaces, materials, and mounting features shall be compatible with the existing NASA configuration unless NASA approves a deviation in writing. No substitution or design deviation is permitted without prior written NASA approval.

Pre-Decisional Draft | Acquisition Planning

NASA | WHITE SANDS TEST FACILITY

4. Scope of Work

1.
2.
3.
4.
5.

Review the NASA furnished Statement of Work information and identify any conflicts before fabrication. Prepare and submit fabrication drawings and code calculations for NASA review.

The beginning of the document. Download the full file to read on.