Statement of Work FMS PN

STATEMENT OF WORK

SUPPLEMENTAL V WIRING SYSTEM REPAIR SET

FOR THE V-22 AIRCRAFT

1.0

SCOPE

This Statement of Work (SOW) establishes the tasks that must be performed by the contractor for the manufacture, assembly, inspection and delivery of Intermediate (I) Level Peculiar Support Equipment (PSE) end items in support of the Japan Ground SelfDefense Force (GOJ/JGSDF) MV-22B Block C Tiltrotor Aircraft Program via Foreign Military Sales (FMS).

APPLICABLE DOCUMENTS

Drawing 3909AS9999, Rev B

MIL-HDBK-61A

MIL-HDBK-781A

MIL-STD-130

DFARS Clause 252.204-7012
Drawing 4271AS0230, Rev A
Drawing 4271AS0232
Drawing 4271AS0231, Rev A
2.0

REQUIREMENTS

2.1

General

Identification Plate Support Equipment
Configuration Management Guidance
Reliability Test Methods, Plans, and Environments
For Engineering Development, Qualification, and
Production
Identification Marking of U.S. Military Property
Safeguarding Covered Defense Information and
Cyber Incident Reporting
Drawing Package (drawing 4271AS0230rAs1)
Drawing Package (drawing 4271AS0232r-s1)
Drawing Package (drawing 4271AS0231rAs3)

The contractor shall provide materials and services as required to procure, manufacture, assemble, inspect and deliver quantity below to support V-22 FMS outfitting of the OLevel PSE end item in accordance with the respective Government furnished drawing package as called out below:

CLIN

Platform

Part
Number

NIIN

Nomenclature

Qty

1001

V-22 FMS

4271AS0230-1

LLERG9722

SUPPLEMENTAL V WIRING

SYSTEM REPAIR SET

2.2

Item Unique Identification (IUID) Marking of US Military Property

In accordance with DFARS Clause 252.211-7003 Item Identification and valuation, the contractor is required to mark and register all end items and their components meeting the requirements called out in latest version of MIL-STD-130 at time of contract award. These include components for which the Governments unit acquisition cost is $5,000 or greater, or any component, subassembly or embedded part that is serially managed, mission essential or a controlled inventory item.

2.2.1

Construct and Method

Details on creating the UID and the marking method are contained in MIL-STD-130N. The UID may be either UID Construct #1 or Construct #2 with Construct #2 being the preferred method.
2.2.2

UID Location and Marking

The locations and marking methods selected should bear no impact on the performance of the part and minimal configuration change(s) to the part. The UID (including 2D Matrix) should be incorporated onto the data plate, in accordance with drawing 3909AS9999 Rev