Technical Requirements Document

TECHNICAL SPECIFICATIONS AND INSTRUCTIONS

SPRBL1-26-R-A003

Light Interference Filter for PSQ-20B

Prepared By:Reviewed By:

X X
Matthew EberhardtTim Langan

SCOPE3

APPLICABLE DOCUMENTS3

CONFIGURATION BASELINE4

REQUIREMENTS4

INTERCHANGEABILITY, INTERFACE, AND PERFORMANCE CHARACTERISTICS . 5 PACKAGING5

ENGINEERING7

PROGRAM MANAGEMENT REQUIREMENTS7

QUALITY MANAGEMENT8

GOVERNMENT TESTING9

SECURITY REQUIREMENTS9

CONTRACT DATA REQUIREMENT LIST (CDRL) DD 1423-110

ENGINEERING CHANGE PROPOSAL10

REQUEST FOR VARIANCE12

NOTICE OF REVISION14

FAILURE ANALYSIS AND CORRECTIVE ACTION REPORT16

OPERATIONS SECURITY (OPSEC) PLAN18

SCOPE

This document specifies the tasks and efforts the contractor shall perform during this production contract of the Light Interference Filter (herein LIF) for the AN/PSQ-20B Enhanced Night Vision Goggles. The LIF is a critical component of the Enhanced Night Vision Goggles (ENVG: PSQ- 20B). The ENVG is a night vision system that amplifies ambient light and provides improved night vision. The LIF is an important component that contributes to the improved night vision.

This document provides the technical, safety, and interchangeability requirements for the items being sought under this procurement. The contractor shall ensure that the delivered LIFs comply with the requirements listed in the Requirements section. The offeror is encouraged to use commercial/industrial processes and practices that will reduce design, production, and operational support costs while meeting the requirements of this contract.

APPLICABLE DOCUMENTS

The documents in the table below can be obtained directly from the publisher. The equipment on contract will be produced in accordance with these documents.

The offeror is responsible for reviewing the entire solicitation/contract to identify all directly cited and subsequently referenced documents. Immediately upon completion of this review, the offeror will notify the Procuring Contract Officer (PCO) of any conflicts and/or misunderstandings between this provision and other contractual requirements.

Notes for Government-furnished drawings:
The drawings specified in this solicitation are for reference only and shall be used for interchangeability purposes. They do not contain complete details of all intervening processes, from raw material to finished products, which are necessary to fabricate, control, test, adjust, assemble and inspect the items on order.

Military and Federal Standards

MIL-STD-129R

Military Marking for Shipment and Storage

MIL-STD-2073-1E w/Chg. 1