LOX 26Z6AL1 RplFireEscapeDoors FCI 1 Statement of Work Approved

U.S. Department of Justice
Federal Bureau of Prisons
Facilities Management
Washington, DC 20534

May 7, 2026

MEMORANDUM FOR JOHN CALTON, FACILITY MANAGER

FCC LOMPOC

THRU:

Kimberly Hudson, Chief
Construction and Environmental Review Section

FROM:

Julius Buyag, Engineering Technician
Construction and Environmental Review Section

SUBJECT:

Statement of Work Approval for Project 26Z6AL1
Replace Fire Escape Doors FCI 1

The Construction and Environmental Review Section, Facilities Management, has reviewed and approved the Statement of Work to be used for solicitation services at FCC Lompoc for Project 26Z6AL1, Replace Fire Escape Doors FCI 1. There are no additional square footage or modifications to the primary structure, nor changes to the utilities to this project. This Statement of Work specifically addresses the Replace Fire Escape Doors FCI 1 under Project 26Z6AL1 as defined herein and should not be interpreted as an open-ended approval for future, unrelated work.
If you have any additional questions or concerns, please email Julius Buyag, Engineering Technician, at [email protected].
Cc: Regional Facilities Administrator

FEDERAL BUREAU OF PRISONS

FCC LOMPOC

B&F PROJECT # 26Z6AL1 REPLACE FIRE ESCAPE DOORS FCI I

STATEMENT OF WORK / REQUEST FOR QUOTE

A. INTRODUCTION:

1. The Federal Bureau of Prisons (FBOP), FCC Lompoc, 3901 Klein Blvd., Lompoc, CA 93436, is seeking quotes from qualified vendors for the supply and delivery of nine (9) complete fire escape door assemblies, including doors, frames, and all required hardware. The doors are for a prison facility application and must meet all relevant local, state, and federal fire and life safety codes.
2. "Equal or Better" Product Substitution: Proposals must meet or exceed the specified product quality. If an alternative product or component is offered, the vendor must submit all technical documentation, certifications, and test results for consideration. 3. Government's Right of Final Technical Acceptance: The government retains the sole and final authority to determine technical acceptance for all submitted products, based on the provided documentation and compliance with stated standards.

B. SCOPE OF WORK:

1. The vendor shall provide all materials as specified below. All components must be new, U.L. Listed or labeled by a recognized testing agency acceptable to the Authority Having Jurisdiction (AHJ) and conform to the standards referenced herein.

C. TECHNICAL SPECIFICATIONS:

TABLE 1: COMPONENTS: All units shall be identical unless otherwise noted.