Performance Work Statement

PERFORMANCE WORK STATEMENT (PWS)

Repair and Calibration Services on Multiple Keysight Test Equipment

1 September 2026

1. DESCRIPTION OF SERVICES/GENERAL INFORMATION

1.1

Scope
This performance work statement establishes calibration and repair services for the Air Force Research Laboratory (AFRL), RF Sensing Dominance Division (RFD), and Electronic Devices Branch (RFDD), at Wright Patterson Air Force Base (WPAFB) for the Keysight test equipment referenced in PWS attachment entitled, “Equipment List.” The services required are calibration services as specified in manufacturer manual of the respective instrument and repairs. Service requirements are specified in detail on the PWS attachment entitled, “Equipment List.” Some of the equipment would be calibrated and or repaired on-site, at WPAFB, while others would be sent to the contractor for calibration or repair.

1.2

Technical Plan of Support for Repair and Calibration Service on Keysight Test Equipment The contractor shall provide services for the on-site calibration and repair as well as calibration and repair at the contractor’s facilities for Keysight equipment. The equipment related to this service along with the type of service is listed in the PWS attachment entitled, “Equipment List.” The contractor shall perform the requested service, detailed in the attached list.

1.2.1

Calibration

1.2.1.1

Requirements
The contractor shall provide On-site calibration or Return-to-Contractor calibration for the instrumentation, as determined in the attached Equipment List. The calibration service shall meet the following standards: traceability to National Institute of Standards and Technology (NIST) standards and acceptable by Precision Measurement Equipment Laboratory (PMEL), Located in Building 884, Area A, 5060 Pearson Road, WPAFB, and or by AFMETCAL, located in 813 Irving Wick Dr. W. Bldg. 2. Heath, OH 43056-1199. The suitability is determined (by PMEL and or AFMETCAL) inspecting a sample of calibration report to verify the requirements specified in Paragraph 4.5.1.4 of TO-00-20-14 are met. In general, if the commercial laboratory can provide a certification that meets the requirements of ISO/IEC 17025, this will meet the 00-20-14 requirements and the calibration will be deemed acceptable. Contractor must meet the requirements in Technical Order (TO) 33K-1-100-2 Equipment Calibration Requirements List as determined in Technical Order TO-00-20-14 Air Force Metrology and Calibration Program. The contractor shall calibrate all equipment on the PWS attachment entitled, “Equipment List” in accordance with the