Specifications Traditional Asbestos Abatement

01-01-21

SECTION 02 82 11

TRADITIONAL ASBESTOS ABATEMENT

PART 1 - GENERAL

1.1 SUMMARY OF THE WORK

A. Contract Documents and Related Requirements: Drawings, general provisions of the contract, including general and supplementary

conditions and other Division 01 specifications, shall apply to the work of this section. The contract documents show or describe the work to be done under the contract and related requirements and conditions impacting the project. Related requirements and conditions include applicable codes and regulations, notices and permits, existing site conditions and restrictions on use of the site, requirements for

partial owner occupancy during the work, coordination with other work and the phasing of the work. In the event the Asbestos Abatement Contractor discovers a conflict in the contract documents and/or requirements or codes, the conflict must be brought to the immediate

attention of the Contracting Officer for resolution. Whenever there is a conflict or overlap in the requirements, the most stringent shall

apply. Any actions taken by the Contractor without obtaining guidance from the Contracting Officer shall become the sole risk and responsibility of the Asbestos Abatement Contractor. All costs incurred due to such action are also the responsibility of the Asbestos Abatement Contractor.

B. Extent of Work:

1. Below is a brief description of the estimated quantities of asbestos containing materials to be abated. These quantities are for

informational purposes only and are based on the best information available at the time of the specification preparation. The

Contractor shall satisfy themselves of the actual quantities to be abated. Nothing in this section may be interpreted as limiting the extent of work otherwise required by this contract and related documents.

2. Removal, clean-up and disposal of asbestos containing materials (ACM) and asbestos/waste contaminated elements or debris in an

appropriate regulated area for the following approximate quantities;

02 82 11 - 1

01-01-21
(2300) Square feet floor and mastic include carpet and levelers of ACM contaminated materials.

(100) Linear feet of radiator panel insulation and radiator heat shield.

C. Tasks:

1. The work tasks are summarized briefly as follows:

a. Pre-abatement activities including pre-abatement meeting(s), inspection(s), notifications, permits, submittal approvals,

regulated area preparations, emergency procedures arrangements, and standard operating procedures for asbestos abatement work.