Hipcan Width MITR
Updated
A PDF document (38 KB) attached to HIP CAN Study, from the Department of Energy. Due Nov 9, 2026, 4:00 PM (UTC-8).
File name: Hipcan_Width_MITR.pdf
The full file is for paid members, or buy this bid alone.
Preview
INNER LENGTH
B
2x 1.125
40.125±.020
B
A
APPLY NEOLUBE TO
INNER SURFACE ONLY
NON-PART NUMBER SIDE.
6.10±.02
INNER WIDTH
R1.50
A
0.06
MAX DRAFT ANGLE: 2%
R.20
18 GAUGE
6.10±.02
C
.99
R.125
A
SECTION A-A
SCALE 1 : 1
DETAIL C
SCALE 2 : 1
1. SPRAY NEOLUBE 1.1 ON ALL SURFACES UNLESS OTHERWISE NOTED PER MANUFACTURER’S DIRECTIONS, BAKE ALL PARTS PER MANUFACTURER’S INSTRUCTIONS.
NOTE: BREAK ALL SHARP EDGES
2. INDIVIDUALLY VACUUM SEAL PARTS INDIVIDUALLY IN 5MIL MYLAR BAGS OR BUYER APPROVED EQUAL. 3. ADD SAP NUMBER AND SERIAL NUMBER TO EACH SEALED BAG WITH A 1 X 3 HARSH ENVIRONMENT THERMAL TRANSFER LABEL OR BUYER APPROVED EQUAL.
4. ELECTROCHEMICALLY ETCH OR LASER ENGRAVE PARTS WITH SAP NUMBER, LOT, AND SERIAL NUMBER 0.13” HIGH AND NO MORE THAN 0.002" DEEP. FORMAT IS: 10 DIGIT SAP NUMBER - 5 DIGIT LOT NUMBER-8 DIGIT SERIAL NUMBER
(XXXXXXXXXX-XXXXX-XXXXXXXX) OR BUYER APPROVED EQUAL
UNLESS OTHERWISE SPECIFED:
ALL DIMENSIONS ARE INCHES
DATE
PROJECT:
DRAWN BY: Fiona Gailey
07/20/2026
STANDARD TOLERANCES: INCHES
APRROVED BY: Taylor Mason
08/06/2026
LENGTH
.0 = ±.1
.00 = ±.01
.000 = ±.005
.0000 = ±.005
REVIEWED BY: Dustin Clelland
08/06/2026
SURFACE FINISH
RMS
µ in
MATERIAL:
XX.XX lb
ANGULAR ± 0.5
THIRD ANGLE PROJECTION
WEIGHT:
A
PART NUMBER:
MITR PLATE
SAP NUMBER:
C61T01V0
XXXXX
REV.
TITLE:
HIP CAN
SIZE
B
SCALE: 1:4
SHEET 1 OF 2
The beginning of the document. Download the full file to read on.