Bid document

Tinker AFB, OK

TAFB Technical Sprcifications 2019

SECTION 23 05 93

TESTING, ADJUSTING, AND BALANCING FOR HVAC

PART 1

1.1

GENERAL

REFERENCES

The publications listed below form a part of this specification to the extent referenced. The publications are referred to within the text by the basic designation only.

ACOUSTICAL SOCIETY OF AMERICA (ASA)

ASA S1.11 PART 1

(2014) American National Standard
Electroacoustics – Octave-Band and
Fractional-Octave-Band Filters – Part 1:
Specifications

ASA S1.4

(1983; Amendment 1985; R 2006)
Specification for Sound Level Meters (ASA
47)

AMERICAN SOCIETY OF HEATING, REFRIGERATING AND AIR-CONDITIONING

ENGINEERS (ASHRAE)

ASHRAE HVAC APP IP HDBK

(2011) HVAC Applications Handbook, I-P
Edition

ASHRAE HVAC APP SI HDBK

(2015) HVAC Applications Handbook, SI
Edition

ASSOCIATED AIR BALANCE COUNCIL (AABC)

AABC MN-1

(2002; 6th ed) National Standards for
Total System Balance

AABC MN-4

(1996) Test and Balance Procedures

NATIONAL ENVIRONMENTAL BALANCING BUREAU (NEBB)

NEBB MASV

(2006) Procedural Standards for
Measurements and Assessment of Sound and
Vibration

NEBB PROCEDURAL STANDARDS

(2005) Procedural Standards for TAB
(Testing, Adjusting and Balancing)
Environmental Systems

SHEET METAL AND AIR CONDITIONING CONTRACTORS' NATIONAL ASSOCIATION

(SMACNA)

SMACNA 1780

(2002) HVAC Systems - Testing, Adjusting
and Balancing, 3rd Edition

SMACNA 1858

(2004) HVAC Sound And Vibration Manual First Edition

April 2019

SECTION 23 05 93

Tinker AFB, OK

TAFB Technical Sprcifications 2019

SMACNA 1972 CD

1.2

(2012) HVAC Air Duct Leakage Test Manual 2nd Edition

DEFINITIONS

a.

AABC:

Associated Air Balance Council

b.

COTR:

Contracting Officer's Technical Representative

c.

DALT:

Duct air leakage test

d.

DALT'd:

e.

HVAC: Heating, ventilating, and air conditioning; or heating, ventilating, and cooling

f.

NEBB:

g.

Out-of-tolerance data: Pertains only to field acceptance testing of Final DALT or TAB report. When applied to DALT work, this phase means When applied to TAB work this phase means "a measurement taken during TAB field acceptance testing which does not fall within the range of plus 5 to minus 5 percent of the original measurement reported on the TAB Report for a specific parameter."

h.

Season of maximum heating load: The time of year when the outdoor temperature at the project site remains within plus or minus 30 degrees Fahrenheit of the project site's winter outdoor design temperature, throughout the period of TAB data recording.

i.

Season of maximum cooling load: The time of year when the outdoor