Attachment 2: Mechanical BOA Drawings FOR BID

GENERAL NOTES:

1.

DRAWING SPECIFICATIONS ARE PART OF THIS CONTRACT.

2.

ALL WORK SHOWN ON THESE PLANS SHALL BE PROVIDED UNDER THIS CONTRACT UNLESS SPECIFICALLY CALLED OUT OTHERWISE.

AC

ACCU

3.

ALL WORK SHOWN ON THESE PLANS SHALL BE NEW.

4.

THE DRAWINGS SHOW THE GENERAL ARRANGEMENT OF ALL DUCTWORK, PIPING AND EQUIPMENT AND INDICATE THE REQUIRED SIZE AND POINTS OF TERMINATION OF THE DUCTWORK AND PIPING AND SUGGEST PROPER ROUTING OF SAME. HOWEVER, IT IS NOT THE INTENTION OF THE DRAWINGS TO SHOW ALL NECESSARY OFFSETS, OBSTRUCTIONS OR STRUCTURAL CONDITIONS. IT SHALL BE THE RESPONSIBILITY OF THIS CONTRACTOR TO INSTALL HIS WORK IN SUCH A MANNER THAT IT WILL CONFORM TO THE STRUCTURE, AVOID OBSTRUCTIONS, PRESERVE HEADROOM AND KEEP OPENINGS AND PASSAGEWAYS CLEAR WITHOUT FURTHER CONSTRUCTION OR COST.

5.

6.

7.

8.

9.

10.

INSTALL WORK SO AS TO BE READILY ACCESSIBLE FOR OPERATING, MAINTENANCE AND REPAIR. MINOR DEVIATIONS FROM DRAWINGS MAY BE MADE TO ACCOMPLISH THIS, BUT CHANGES OF MAGNITUDE WHICH INVOLVE EXTRA COST SHALL NOT BE MADE WITHOUT APPROVAL. EQUIPMENT MANUFACTURER'S RECOMMENDED SERVICE CLEARANCES SHALL BE ADHERED TO IN ADDITION TO INDUSTRY STANDARDS AND CODE REQUIREMENT. IF PROPER SERVICE CLEARANCES CAN NOT BE MAINTAINED FOR ANY REASON THEN CONTRACTOR SHALL NOTIFY OWNER AND ARCHITECT ASAP.

THE CONTRACTOR SHALL TAKE PRECAUTIONS AGAINST DAMAGING OR DISRUPTING BUILDING SYSTEMS, WIRING, PIPING OR CONTROL WIRING. ANY DAMAGE TO THESE ITEMS SHALL BE REPAIRED AT THE CONTRACTOR'S COST, WITHIN COST, WITHIN THIS CONTRACT PERIOD FOR SUBSTANTIAL COMPLETION. THE CONTRACTOR SHALL REPAIR AND RESTORE TO ORIGINAL CONDITION ANY EQUIPMENT OR MATERIALS DAMAGED IN THE PROCESS OF INSTALLATION, AND DEMOLITION TO THE SATISFACTION OF THE OWNER'S REPRESENTATIVE.

11.

THE CONTRACTOR SHALL MAKE REPAIRS USING THE SAME MATERIALS, AT THE CONTRACTOR'S COST.

12.

THE CONTRACTOR SHALL INCUR ALL COSTS AND BURDENS ASSOCIATED WITH LOST OR STOLEN EQUIPMENT AND MATERIALS.

13.

HOT WATER PUMP

HR

HOT WATER RETURN

HS

HOT WATER SUPPLY

AL

ACOUSTICAL LINING

HZ

HERTZ

AS

AIR SEPARATOR

IN.

INCHES

AV

AIR VENT

B

BOILER

K

BNL EQUIPMENT DESIGNATION LETTER

BB

BASEBOARD

L

LENGTH

BHP

BRAKE HORSEPOWER

LAT

LEAVING AIR TEMPERATURE

BOT.

BOTTOM

LFT

LEAVING FLUID TEMPERATURE

BSMT.

BASEMENT

LWCO

IN.W.G.

INCHES WATER GAUGE

LWT

LEAVING WATER TEMPERATURE

BTU/HR

MAX.

MAXIMUM

CONDENSATE

MBH

THOUSAND BTUH

CAP.

CAPACITY

MCA

MINIMUM CIRCUIT AMPACITY

CFM

CUBIC FEET PER MINUTE

MER

MECHANICAL EQUIPMENT ROOM

CW1

CITY WATER SUPPLY

MEZZ.

MEZZANINE

CR

CHILLED WATER RETURN

MIN.

MINIMUM

CS

CHILLED WATER SUPPLY