Bid document
Updated
A PDF document (42 KB) attached to WWYK250063 - Install React VII Facility, B9001, Post V19, from the Department of the Air Force. Due Nov 2, 2026, 2:00 PM (UTC-6).
File name: 05 40 00.pdf
The full file is for paid members, or buy this bid alone.
Preview
Tinker AFB, OK
TAFB Technical Sprcifications 2019
SECTION 05 40 00
COLD-FORMED METAL FRAMING
PART 1
1.1
GENERAL
REFERENCES
The publications listed below form a part of this specification to the extent referenced. The publications are referred to within the text by the basic designation only.
AMERICAN CONCRETE INSTITUTE INTERNATIONAL (ACI)
ACI 318
(2014; Errata 1-2 2014; Errata 3-5 2015;
Errata 6 2016) Building Code Requirements
for Structural Concrete and Commentary
AMERICAN IRON AND STEEL INSTITUTE (AISI)
AISI S100
(2012) North American Specification for
the Design of Cold-Formed Steel Structural
Members
AISI S110
(2007; Suppl 1; Reaffirmed 2012) Standard
for Seismic Design of Cold-Formed Steel
Structural Systems - Special Bolted Moment
Frames
AISI S200
(2007) North American Standard for
Cold-Formed Steel Framing - General
Provision
AISI S201
(2007) North American Standard for
Cold-Formed Steel Framing - Product Data
AISI S202
(2011) Code of Standard Practice for
Cold-formed Steel Structural Framing
AISI S211
(2007) North American Standard for
Cold-Formed Steel Framing - Wall Stud
Design
AISI S212
(2007) North American Standard for
Cold-Formed Steel Framing - Header Design
AISI S213
(2007; Suppl 1 2009) North American
Standard for Cold-Formed Steel Framing Lateral Design
AISI S214
(2012) North American Standard for
Cold-Formed Steel Framing – Truss Design
AMERICAN WELDING SOCIETY (AWS)
AWS D1.1/D1.1M
April 2019
(2015; Errata 2015) Structural Welding
Code - Steel
SECTION 05 40 00
Tinker AFB, OK
AWS D1.3/D1.3M
TAFB Technical Sprcifications 2019
(2008; Errata 2008) Structural Welding
Code - Sheet Steel
ASTM INTERNATIONAL (ASTM)
ASTM A1003/A1003M
(2015) Standard Specification for Steel
Sheet, Carbon, Metallic- and
Nonmetallic-Coated for Cold-Formed Framing
Members
ASTM A123/A123M
(2013) Standard Specification for Zinc
(Hot-Dip Galvanized) Coatings on Iron and
Steel Products
ASTM A153/A153M
(2016) Standard Specification for Zinc
Coating (Hot-Dip) on Iron and Steel
Hardware
ASTM A307
(2014) Standard Specification for Carbon
Steel Bolts and Studs, 60 000 PSI Tensile
Strength
ASTM A370
(2014) Standard Test Methods and
Definitions for Mechanical Testing of
Steel Products
ASTM A653/A653M
(2015) Standard Specification for Steel
Sheet, Zinc-Coated (Galvanized) or
Zinc-Iron Alloy-Coated (Galvannealed) by
the Hot-Dip Process
ASTM C1007
(2011a) Standard Specification for
Installation of Load Bearing (Transverse
and Axial) Steel Studs and Related
The beginning of the document. Download the full file to read on.