TE-09a Fugitive Dust Control Form 01-Crushing

Dugway Proving Ground Fugitive Dust Control Plan Form 01 Sand and Gravel Borrow Pit Operations

Crushing of Rock, Soil, or Construction Debris
Activity Description: The process of reducing the size of materials by physical impaction.

General Information
Location(s):

Start Date:

End Date:

Point of Contact:

Email:

Phone Number:

Description of site:

Fugitive Dust Emission Control Techniques
Select at least one best management practice (BMP) for each critical mitigation area: Stabilize surface soils where support equipment and vehicles will operate BMP 01-01 Pre-water and maintain surface soils in a stabilized condition. BMP 01-02 Apply and maintain a chemical stabilizer to surface soils. (Name of chemical: )
BMP 01-03 Pave operational area(s).
Stabilize materials before crushing
BMP 01-04 Pre-water material.
BMP 01-05 Test material to determine moisture content and silt loading, crushing only material that is at optimum moisture content. Stabilize material during crushing
BMP 01-06 Apply water to stabilize material so as to maintain compliance with opacity standards and permit conditions. BMP 01-07 Monitor opacity. Make adjustments to maintain compliance with opacity standards and permit conditions. BMP 01-08 Install wind breaks or use enclosure.
Stabilize material after crushing
BMP 01-09 Water crushed material immediately following crushing. BMP 01-10 Apply and maintain a chemical stabilizer to crushed material. (Name of chemical: )
BMP 01-11 Maintain in enclosure.
BMP 01-12 Minimize height of stockpile.
Traffic
BMP 01-13 Minimize vehicle miles.
BMP 01-14 Reduce truck traffic.
BMP 01-15 Reduce truck speed.
Transfer height
BMP 01-16 Minimize transfer and drop point height.

Logbook Requirement

All crushing operations require a logbook be kept, at minimum, it must contain: the date and amount of material crushed. If suppression is used, (i.e. water/chemical suppressant), additional logbook entries are required, at minimum, entries must contain: the date, time, type of suppression used, amount (in gallons), purpose and location applied.

Trackout Prevention

In accordance with Utah Administrative Code R307-205-6(2), any person(s) performing fugitive dust emission activities will to the maximum extent possible, keep material from being deposited onto any paved road other than a designated deposit site. Any such person(s) who deposits materials that may create fugitive dust on a paved road shall clean the road promptly. *By signing you attest that you have read and understand the requirements of the DPG FDCP and will follow the BMPs you have selected.